Printable View
750-850Hz is what I would aim for at first. We shall see!
The tweeters can roll in about 3.5KHz and make up for the drooping 288. But they won't extend the FR any higher. 15K will be it. Or maybe bring them in much higher with a HP shelf on the 288. TBD.
Getting on out past 20K with good efficiency is not easy. The T-350 may not be the right driver for the job.
Well woofers arrived today.But boy do I have a thing or two to say about UPS and none of it is any good !! Went out to meet the driver and as I approched the truck I seen my package bounce of the floor.That's when he almost bounced off the asphalt. :mad:. Throwing the boxes around like a football.That's when I had to speak my mind.The drivers are Pristine and to throw them around like a football is Ridiculous !!
http://www.hostboard.com/forums/hbmc...2010/09/31.jpg
http://www.hostboard.com/forums/hbmc...2010/09/32.jpg
Glad the drives are OK.
That's why I use FedEx ground these days. UPS is too rough.
Thanks !Quote:
Originally Posted by Pano
Okay, does this zipped folder open for anyone after its downloaded ?
( I get a message saying it's corrupted and that there's nothing within it to extract )
<> cheers
I just downloaded and opened it. I see and can open all the text files. So it didn't get hurt going up.
Thanks for your affirmation .Quote:
Originally Posted by Pano
I've just successfully unzipped it with my old Mac / & it's all good upon importation to REW . ( Must have been my antiVirus software holding things up )
I'll get back to this tomorrow &/or the weekend .
<> cheers
Cool Earl.
I'm hoping that AB gets a chance to do off axis plots of the T-350 this weekend.
Cause on axis, I don't see it as being very useful. It barely goes higher than the 288. I see the 288/511 as going to 13K then dropping off 5th order - that's typical. The T-350 goes to ~15K then drops off at what looks like about 6th order.
But maybe it will fill in off axis enough to make it useful. Otherwise, what to use? One of the Fostex super-tweeters?
Sorry for the delay guys my wife is having surgery this morning so I have been tending to her.Will get it done soon.
No worries! All the best wishes for her. Hope she does just fine.
Thanks Michael ! :) She is doing well Thankfully ! :2thumbsup: